RabbitLink EG2110 Instrukcja Użytkownika Pobierz pdf (Strona 18)

14 RabbitLink (EG2110)

3. Configure the RabbitLink network parameters. This is done using the serial console

commands. Typing the command “show” results in a listing of the current network

addresses.

Please refer to Appendix E, “Serial Console Commands,” for a description of all the

commands. If a DHCP server was not used, the following serial console commands are

required:

set ip x.x.x.x // factory default is 10.10.1.100

set gateway x.x.x.x // factory default is 10.10.1.1

set netmask x.x.x.x // factory default is 255.255.255.0

An alternative for setting the required network addresses is to change the default values

in the RabbitLink firmware, download.c.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Brak uwag

RabbitLink EG2110 Instrukcja Użytkownika Strona 18